Galvanized Iron Primer – 20L
Primes galvanised metal roofs for application of roof membrane [20L]
$224.07
- Description
- Additional information
- Safety Data Sheet (SDS)
Description
Sunbond Galvanized Iron Primer
Quick drying water borne primer for galvanised iron, zinc-alume, and aluminum surfaces.
SUNBOND GAL IRON PRIMER contains non-toxic anticorrosive pigment to control oxidation and “white rust” of galvanised iron and aluminum. The primer is acrylic based and is highly resistant to the alkaline reaction of galvanised iron.
The Primer is compatible with most finish coats and may be recoated with acrylic, vinyl, or oil based undercoats and enamel top coats.
Intended Uses:
As a primer specifically formulated for galvanised iron, zinc- alume, and aluminum surfaces.
Note Iron or steel brackets or fixtures which are not galvanised should be primed with a premium quality Anti Corrosive Metal Primer, following correct surface preparation.
Properties
| Gloss level: | Low sheen |
| Exterior durability: | Excellent when recoated with recommended top coats |
| Colour: | Light Grey only |
| Washability: | Excellent |
| Coverage: | Up to 12 square metres per litre |
| Number of Coats: | 1 coat is normally sufficient |
| Recoat time: | 24 hours in normal conditions (Longer should be allowed in damp, humid, or cold conditions) |
| Thinning: | Up to 5% with water |
| Clean Up: | Water |
Surface Preparation
- New Surfaces
Remove all dust and dirt. Wash surface with mineral turps and then thoroughly with water to remove all traces of forming oil, grease, and other contaminants.
- Previously Painted Surfaces
Remove all unsound cracking or flaking paint with scraping and sanding. Remove all rust, chalk, dust, oil, grease and other contaminants including any “white rust” deposits.
Ensure any rusted areas on galvanised iron, steel brackets etc are thoroughly abraded to remove rust and are primed with Anti Corrosive Metal Primer before applying Gal Iron Primer.
Application
ONE coat of GAL IRON PRIMER is recommended. Apply by airless spray. Use a brush on small and difficult areas.
OTHER INFORMATION
Thoroughly stir paint in a circular lifting motion using a flat paddle. Thin up to 5% with water (only if necessary) to assist application in hot windy conditions. Do not apply at surface temperatures below 10 degrees Celsius and cease application if surface dry time exceeds 40 minutes.
Do not apply if rain or moisture condensation is imminent. (Do not apply to exterior surfaces after 3 pm if overnight dew condensation is likely)
Additional information
| Weight | 20 kg |
|---|
SUNBOND GAL IRON PRIMER WITH NoRust - Material Safety Data Sheet:
Related Products
-
Add to cartQuick ViewCement Tile Sealer – 20L
$149.38Roofshields Cement Tile Sealer is specifically designed for aged or warn roofs. [20L]
Add to cartQuick View -
Add to cartQuick ViewCement Tile Primer – 20L
$142.23Water based, methyl methacrylate, adhesion promoted acrylic primer for application to cleaned cement tiles as the first coat of the Sunbond Tile Restoration Coating system [20L]
Add to cartQuick View -
Select optionsQuick ViewHeat Shield Membrane – 20L
$231.00HEAT SHIELD is a high build heat reflective roof coating specifically formulated to minimise roof temperatures by reflecting solar heat.
Select optionsQuick View -
Add to cartQuick ViewOld Tile/High Build Sealer/Primer – 20L
$187.88Old tile sealer is specifically designed for roof tiles that have severely deteriorated surfaces.
Add to cartQuick View
